What does the PubSub GCP connector do?
The PubSub connector configures and verifies the connection to the Google Cloud Pub/Sub service, attempting to consume a message from the topic specified in the configuration. It records whether the operation was successful or if there were failures throughout the process, updating the monitoring status.
How to monitor PubSub on One Platform
1 – In the side menu, click on Services Hub
2 – In the Queue category, click on the PubSub (GCP) card
3 – You will be directed to the GCP PubSub configuration form, fill in the fields
4 – If you want, you can configure automatic incident opening. In the Open automatic incident section, fill in the fields:
- Severity -> Choose between “SEV-1 – Critical”, “SEV-2 – High”, “SEV-3 – Moderate”, “SEV-4 – Low”, “SEV-5 – Informational” or “Not Classified”;
- Check Interval in seconds -> This is the interval at which checking will take place (this interval cannot be less than the number of failures x the Interval configured in the monitoring form;
- Failures to open automatic incident -> It is the number of failures necessary to open the automatic incident;
- Check Interval in seconds -> This is the interval in which checking will take place (this interval cannot be less than the number of hits x the Interval configured in the monitoring form;
- Hits to close automatic incident -> It is the number of hits needed to close the automatic incident;
- Responders -> These are the teams that will be notified if there are incidents in this monitoring, and you can add one or multiple teams;
If necessary, you can create a team by clicking + RESPONDER, you will be directed to the form
to create the team, then click on the button 
for the new team to appear in the list
***Don’t forget to activate the Enable to set up automatic incidents opening toggle to save the automatic incident opening settings
5 – Click on CREATE MONITORING
